Welcome to the FRP Bridge decking website from krafton®

krafton® 236.40 FRP Bridge Decking Plank

With its width of 236 mm, this is a unique FRP bridge decking plank within the krafton® range. Its limited width of less than 300 mm makes this plank very easy to handle. It is often used for pedestrian bridges, jetties, boardwalks and terraces.

The practical click system neatly conceals the screws, resulting in a closed bridge deck. Rainwater is drained off to the side, to prevent water from affecting the support structure.

These FRP profiles are quick and easy to install from above with a drill and screwdriver. Each tab has a notch to allow the screw to be placed at a straight angle, to prevent the screw from slipping during drilling.

The 236.40 FRP bridge decking plank is highly suitable for mounting on a wooden or plastic support structure. We are the only supplier of FRP bridge decking planks whose planks can also be mounted on a steel support structure with DIBt approval.


Technical information krafton® 236.40
UseUse refurbishment and new construction
Effective dimensions236x40mm
Evenly distributed load5kN / m2 (500 kg per m2)
Exceptionally high point load10 kN (1.000 kg) op 100x100mm
Suitable for service vehicles5 tons (5.000 kg)
Maximum span width for vehicles500mm
Mounting on support structureSteel, composite and wood
InstallationEasy and rapit
Non-slip coatingTÜV-certified non-slip coating (R12-R13) with grain sizes from 0.7 to 3.0 mm
Certifications of this FRP Bridge Decking Plank

This is the strongest plank of this type with DIBt and EBA approval. The krafton® 236.40 FRP bridge decking plank meets the requirements of the Building Decree, NEN-EN 1991-2NB and Eurocode.


This plank has the major advantage of a technically advanced and practically designed click system. As a result, the joints between the planks have optimal contact, allowing them to be and remain perfectly positioned on the support structure.

Moreover, the horizontal notch in the bottom of the FRP plank simplifies and speeds up pre-drilling for screw holes, since the drill bit will not slip. As a result, mounting from above is extra easy and fast.

  • For refurbishment and new construction
  • Effective dimensions: 236x40mm
  • Evenly distributed load of 5kN/m2
  • Point load of 10 kN (1,000 kg) on 100 x 100 mm
  • Point load of 20 kN (2,000 kg) on 200 x 200 mm
  • Maximum span width for vehicles (5 tons): 500 mm
  • Suitable for service vehicles up to 5 tons (5,000 kg)
  • Highly suitable for mounting from above on plastic (a.o. FRP I girder) and wooden support structure
  • Easy and rapid installation
  • TÜV-certified non-slip coating (R12-R13) with grain sizes from 0.7 to 2.0 mm

See next page for detailed Technical Properties krafton® 236.40

Receive within minutes

a customised quotation via our tool

Request a quotation

Do you have a question about our products?

Please feel free to get in touch

Get in touch